Advertisement
73. Secure the antenna cable, the DIN cable, and the
XM radio harness with three wire ties with clips.
Insert the clips on the wire ties into the panel
holes.
ANTENNA
CABLE
74. Using scissors, cut out the shaded areas from the
template.
TEMPLATE
Cut
(shaded areas)
22 of 24
WIRE TIES WITH CLIPS (3)
RADIO
HARNESS
2620050M
DIN CABLE
ANTENNA
CABLE
2527100M
75. Position the template on the right trunk side panel,
and tape the template in place. While wearing eye
protection, center punch the three cross marks on
the template.
MASKING
TAPE
CENTER PUNCH
76. Remove the template. Place a shop towel on the
inside of the right trunk side panel to collect any
metal shavings.
8 mm DRILL BIT
77. Drill three 8 mm holes through the inner panel:
•
Wrap vinyl tape around the drill bit 10 mm from
the end, or attach a drill stop.
•
While wearing eye protection, drill an 8 mm
hole through each center-punched mark.
•
Remove all burrs and metal shavings, and
apply touch-up paint to the edges of each
drilled hole.
•
Remove and discard the shop towel.
AII 24378 (0303)
CROSS MARKS (3)
RIGHT TRUNK
SIDE PANEL
TEMPLATE
SHOP
TOWEL
10 mm
VINYL TAPE
© 2003 American Honda Motor Co., Inc - All Rights Reserved.
2527110M
2527121M
Advertisement
