Advertisement
Installing the Display Module
18. Attach the display module to the display module
pocket:
•
Using isopropyl alcohol on a shop towel, clean
the center on the back of the display module
where the adhesive backing will attach.
•
Remove the backing from one side of the
double-sided adhesive tape, and attach it to
the display module.
•
Remove the remaining backing from the
double-sided adhesive tape. Route the display
module cable through the hole of the display
module pocket, and attach the display module
to the pocket.
DOUBLE-SIDED
ADHESIVE TAPE
BACKING
Without Player
DISPLAY MODULE CABLE
With Player
© 2003 American Honda Motor Co., Inc - All Rights Reserved.
DISPLAY MODULE
Clean with
isopropyl
alcohol.
DISPLAY
MODULE
POCKET
POCKET
PLAYER
DISPLAY
DISPLAY
MODULE
MODULE
POCKET
CABLE
Routing the XM Radio Harness
19. Remove the beverage holder (pull up to release
the six retaining clip).
RETAINING
CLIPS (4)
20. Remove the rear console.
•
Open the lid, and remove the rear console mat
from inside the rear console.
•
Remove the two screws and four self-tapping
screws, and unplug the connector and harness
clip (if equipped).
•
If equipped with a console-mounted CD
changer, remove the changer from the rear
console.
REAR CONSOLE MAT
SCREWS (2)
2N28110M
AII 24378 (0303)
RETAINING
CLIPS (2)
BEVERAGE
HOLDER
2206050K
SELF-TAPPING
SCREWS (4)
HARNESS CLIP
(If equipped.)
CONNECTOR
(If equipped.)
2206090K
9 of 24
Advertisement
