Raymarine Pathfinder Radar Owner's Handbook Manual page 221

Appendix B: Using the Auxiliary Junction Box
Raystar 114 Combined GPS and Differential Beacon
Receiver
To connect your Raystar 114 Combined GPS and Differential Beacon
Receiver to your
insulation on all the wires and connect to the Auxiliary Junction Box as shown
in the illustration below.
CAUTION:
Ensure the correct polarity of the 12 V supply before applying display or
SeaTalk power. It is recommended that a multimeter is used to check the
connections.
Note: You can use the GPS Set-Up page to manually tune the Raystar 114. Re-
fer to Chapter 6 for details.
To Display Unit
SeaTalk Socket
Black
12V
Power
Supply
(fused) Red
2
hsb display, cut off the 5-pin connector, strip back the
B-5
Black From
White
Combined
Red
GPS/DBR
Yellow
sensor
Green
D4301_1