Bosch GLM 100 C Operating/Safety Instructions Manual page 25

Permanent laser beam
Unit of distance measure
(depending on country version)
Unit of angle measure
even from a long distance.
In this setting, the laser beam also remains switched on between
measurements; for measuring, it is only required to press the measuring
button 2 once.
Measuring Functions Length Measurement
For length measurements, press button 12 until the "length measurement"
indication appears on the display.
1
For area/surface measurements, press button 12 until the indicator for area
measurement
1
2
Afterwards, measure the length and the width, one after another, in the
same manner as a length measurement. The laser beam remains switched
1
on between both measurements.
Continuous Laser Beam
Do not point the laser beam at persons or animals
and do not look into the laser beam yourself, not
To switch the laser on and for measuring, briefly press the
measuring button 2 once each time.
The measured value is displayed in the result line c.
For several subsequent length measurements, the last
measured results are displayed in the measured-value
lines a.
Area / Surface Measurement
appears on the display.
Off
On
Off
m, ft, inch, cm, mm, yard
°, %, mm/m, in/ft
-25-