Bosch GLM 100 C Operating/Safety Instructions Manual page 11

• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• C onsult the dealer or an experienced radio/TV technician for help.
"This device has been designed to operate with the antennas listed below,
and having a maximum gain of 1.3 dB. Antennas not included in this list
or having a gain greater than 1.3 dB are strictly prohibited for use with this
device. The required antenna impedance is 50 ohms."
"To reduce potential radio interference to other users, the antenna type and
its gain should be so chosen that theequivalent isotropically radiated power
(e.i.r.p.) is not more than that permitted for successful communication."
"Exposure to Radio Frequency (RF) Signals: The wireless device is a radio
transmitter and receiver. It is designed and manufactured not to exceed
the emission limit for exposure to radio frequency (RF) energy set by
the Ministry of Health (Canada), Safety Code 6. These limits are part of
comprehensive guidelines and established permitted levels of RF energy
for the general population.
These guidelines are based on the safety standards previously set by
international standard bodies. These standards include a substantial safety
margin designed to assure the safety of all persons, regardless of age and
health.
This device and its antenna must not be co-located or operating in
conjunction with any other antenna or transmitter.
This device has been shown to be capable of compliance for localized
specific absorption rate (SAR) for uncontrolled environment / general
public exposure limits specific in ANSI/IEEE C95.1-1992 and had been
tested in accordance with the measurement procedures specified in IEEE
1528-2003."
Important: Some of the following symbols may be used on your tool.
Please study them and learn their meaning. Proper interpretation of these
symbols will allow you to operate the tool better and safer.
Symbol Name
A
Alternating
current
Symbols
Designation/
Explanation
Type or a characteristic
of current
-11-