Running Transducer Cable - Raymarine ST40 Wind Owner's Handbook Manual

Chapter 3: Installation

Running transducer cable

The Rotavecta transducer has a 20 m (65 ft) cable, fitted with spade
terminals at the free end, for connection to the ST40 Wind instrument.
Observing the following guidelines, run the cable to the instrument:
• If the cable has to be fed through the deck, always use a good quality
• Where cables are fed through holes, always use grommets to prevent
• Secure long cable runs so they do not present a hazard.
• Wherever possible, route the cable away from fluorescent lights,
Rail clamp details
Rail diameter 23 mm (0.9 inch) or more but
less than 25 mm (1.0 inch), use adaptor pieces
Using the Rotavecta rail clamp
deck gland.
chafing.
engines, radio transmitting equipment, as these may cause
interference.
Clamp screws
Clamping methods for
different rail sizes
Rail diameter 25 mm (1.0 inch),
Gasket
Adaptor
pieces
Grub screw
do not use adaptor pieces
D4834-1
15