Chapter 3: Installation
Note: If you intend fitting a nonstandard transducer, extra tools may
be required
Site requirements
Rotavecta wind transducer
The Rotavecta wind transducer can be either mounted on a flat surface
or clamped to a horizontal rail. Suitable rail diameters are from 23 mm
(
The Rotavecta must be fitted:
• As high as possible and away from any equipment which may
• In a position which allows reasonable access for installation and
Instrument
29
/
inch) to 25 mm (1 inch).
32
shield the transducer or otherwise disturb the air flow.
servicing.
ST40
126 mm (5.0 in)
Instrument dimensions
4 mm
5 /
(
32
57 mm
(2.25 in)
55 mm
(2.2 in)
30 mm (1.2 in)
minimum cable clearance
21 mm
17 mm
(0.8 in)
(0.67 in)
13
inch)
2.5 mm
1 /
(
inch)
10
D4643-3
70 mm
(2.8 in)
D4644-2