Related Manuals for Klugmann KGO600GGFX
Summary of Contents for Klugmann KGO600GGFX
- Page 1 INSTRUCTION MANUAL Oven KGO600GGFX Klugmann Hausgeraete GmbH. Gropiusstraße 7, 48163 Münster, Deutschland +49 (0)2501 - 963 5732 +49 (0)2501 - 963 1834 service@klugmann-hausgeraete.de www.klugmann-hausgeraete.de...
- Page 2 Klugmann cannot be held responsible for the injuries or losses caused by misuse or wrong installation of the product. Klugmann reserves the right to void the warranty delivered with the product due to wrong installation or misuse of the appliance.
- Page 3 Before First Use - Read the instructions carefully before setting up and using the appliance. - Make sure the appliance is not damaged, after removing it from the packaging. In case of doubt, do not use the appliance and consult your supplier or a competent engineer.
-
Page 4: Important Safety Precautions And Recommendations
-- Let the oven cool down, turn off the power, and then clean the interior of the oven with a cloth dipped in neutral detergent, and wipe dry well. Important Safety Precautions and Recommendations - Do not perform any cleaning or maintenance operation without unplugging the appliance. - Page 5 - Important: This appliance is designed for home use only. It is NOT fit for use in semi- commercial, commercial or common area uses. - Cooking Safely: Keep the foods inside the oven for short durations before and after cooking. This is to prevent contamination by organisms that can cause poisoning. Take special care in hot weather.
- Page 6 CAUTION: Additional ventilation might be required by opening a window or increasing the suction power of the aspirator (if any) when the appliance is used for excessive durations. Gas Oven Technical Specifications Oven is delivered completely clean. Again, it is recommended that the oven is set to maximum temperature in first use to remove the possible oil stains from the oven burner.
- Page 7 Oven might get very hot during operation and very hot steam might come out of the area under the control panel. Keep children away. Door is hot, so use the handle. Appliance gets hot while running. Avoid touching the heating elements inside the oven. How To Use The Oven IMPORTANT INFORMATION: - Do not use the appliance if there is an electrical malfunction or if the cooling fan motor...
-
Page 8: Igniting The Oven Burner
The indicator on the control panel (Figure 3) shows the increasing oven temperature. To regulate the heat, bring the knob onto the selected number. The symbol closest to the maximum position indicates that electrical ignition is built in the knob (it is activated by the knob itself). - Page 9 Some parts might be very hot during and after using the oven. Keep children away. CAUTION: Never turn the thermostat before approaching the "A" hole on the floor in case of a manual ignition. Igniting The Grill Burner IMPORTANT: The oven door must be open after this operation. To ignite the burner: Completely open the oven door.
- Page 10 To reignite the burner, first bring the control knob of the grill to the OFF ("O") position, wait for at least one (1) minute and repeat the ignition procedure. Some parts might be very hot during and after using the grill. Keep children away.
- Page 11 Cooking With Gas Oven Heat the oven to the desired temperature before putting the food in the oven. For correct pre-heating operation, remove the tray and place it with the food after the oven reaches the desired temperature. Check the cooking time and turn the oven 5 minutes before the actual time to use the stored heat.
- Page 12 Cooking Guide Your gas oven has a burner located under the burner cap. If you are accustomed to cook with gas from before, you might have to change your cooking methods slightly. The oven floor is hot and it is ideal for baking the bottom of flat cake molds and pizzas.
- Page 13 Heat Guide SIGN OVEN HEAT FOOD TO BE COOKED Meringue cakes, foods ½th Region Very cold oven cooked in low temperature Rice pudding, cakes with 1. Region Cold oven lots of fruit, i.e. Christmas Stew, casserole, foods 2. Region Cold or slow oven cooked in low fire, rich fruit cakes, i.e.
- Page 14 ~ 13 ~...
- Page 15 ~ 14 ~...
- Page 16 ~ 15 ~...
-
Page 17: Maintenance
Maintenance We recommend that you clean the appliance when it is cold, especially the enamel parts. Avoid using alkaline or acidic materials (lemon juice, vinegar, etc.) on the surfaces. Do not use chlorine or acid-based cleaning agents. WARNING When installed correctly, your product meets all the safety conditions foreseen for this product category. - Page 18 repair and may cause the glass to break. Replacing the Oven Lamp WARNING: To prevent electric shock, make sure the appliance is turned off before replacing the lamp. - Leave the oven gap and heating elements to cool down. - Cut off the power connection. - Remove the protective cover "A"...
- Page 19 Removing the Oven Door Be careful, oven door is heavy. When in doubt, do not try to remove the door. Oven door can be removed as follows: - Open the door to the end (Figure 13) - Completely open the A arm on the left and right hinges (Figure 14). - Hold the door as shown in Figure 12.
- Page 20 Placing the Oven Door Back - Hold the door fast (Figure 17). - Place the hinge latches in the gaps and make sure that the gap is fitted into place as in figure 18. - Open the door to the end. - As seen in Figure 19, completely close the "A"...
- Page 21 Removing the Inner Glass Pane The oven door has two panes: - 1 glass outer - 1 glass inner To clean all panes from both sides, the inner pane must be removed as specified below: 1. Open the door Fig.-20 - Open the door to the end (Figure 20) - Completely open the A arm on the left and right hinges (Figure 21).
- Page 22 Replacing the Inner Glass Pane After Cleaning When replacing the inner glass pane: - make sure you replaced the pane correctly as shown. Pane must be in the position specified below to fit in the door and to ensure oven's safe and correct operation.
- Page 23 What Should / Shouldn't Be Done - Always grill with the door half-open. - Read the user instructions carefully before using the oven for the first time. - Before using the oven for the first time, operate the oven empty for two hours to remove the odors caused by new oven insulation.
- Page 24 Recommendations For The Installer The installation and maintenance of the appliance shall be performed only by AUTHORIZED TECHNICIANS and in accordance with local safety standards. - Warranty becomes void unless this is conformed to. - Cut off the power connection of the appliance when performing any maintenance or repair operation.
- Page 25 Many other methods are available to ventilate the oven. Consult an engineer for advice. Important Ensure that air can flow freely around the case area. Not having enough ventilation can cause the appliance to overheat or cause the units around to malfunction. Place the oven on the rack carefully, but DO NOT lift by the door handle.
- Page 26 Fixing the Oven Place the oven to the gap in the cabinet and fix with 4 screws, as shown in Figure As the purpose of the fixing with screws is only complementary, make sure the oven stands on a surface that supports its weight. To allow 4-5mm gap between the cabinet door and the oven frame, adjust the hinged of the cabinet doors next to the oven.
- Page 27 Ventilation Conditions - In rooms with a volume below 5 m , continuous free air ventilation of 500 is required. - For rooms with a volume between 5 m to 10 m , continuous free air ventilation of 100 cm is required.
-
Page 28: Important Note
Gas Fixture Important Note The appliance is supplied to be used with NATURAL GAS or LPG (Check the gas specification label on the appliance). - Products supplied for NATURAL GAS: are adjusted only for this type of gas and do not work with another gas (LPG) without being modified. Appliances are designed to be converted to LPG. -
Page 29: Gas Connection
Gas Connection Connecting the gas appliance to natural gas or LPG shall be performed by a competent and authorized installer. Installers shall observe the clauses of related British Standards Application Law, Gas Safety Regulation and the Building Standards (Scotland) (Assembly) issued by Scotland Office of Development. - Page 30 to be cut off after the device is moved. Maintenance and Natural gas or LPG conversion Injector Selection Table Category: II 2H3+ BURNERS Nominal Reduced Natural Gas Power Power G30 (28-30 mbar) G20 (20 mbar) [kW] [kW] G31 (37 mbar) Injector Ring gap Injector...
- Page 31 Replacement Operations For Oven and Grill Burner Injectors Some models are provided with an injector set for different gas types. If the injector is not supplied, it can be purchased from Service Center. Select the injectors to be changed from the "Injector Selection Chart" The jet diameters specified in one hundredth of a millimeter are marked on the body of each injector.
- Page 32 Grill Burner - Remove the screws and remove the burner screw "A" (Figure 33). - Remove the burner as shown in Figure 34. Take care not to damage the safety valve probe and electrical ignition electrode. - Remove the screws of the injector using 7 mm box strainer (shown with an arrow in Figure 34) and replace with a new injector selected according to the "Injector Selection Chart".
- Page 33 Primer Air Insufficient Correct Air Primer Air Too Much spread, yellow and light insides blue cone short and sharp too blue inner flickering cone, prone to separation Primer Correc Primer Air t Air Too Much Insufficient CAUSE Air adjustment bottle Bottle in correct Air adjustment bottle open too closed too much...