Related Manuals for Klugmann KO611TCBM
Summary of Contents for Klugmann KO611TCBM
- Page 1 MODEL KO611TCBM KO608PBBM...
- Page 2 СONTENTS 1. PURPOSE AND SCOPE OF USE 2. TECHNICAL PARAMETRES 3. CLASSIFICATION 4. STRUCTURE AND CONSTRCTUION OF THE DEVICE 5. INSTALLATION 6. EXPLOITATION OF THE DEVICE 7. REQUIREMENTS FOR SAFETY LABOUR 8. CLEANING AND MAINTENANCE 9. STORAGE...
-
Page 3: Purpose And Scope Of Use
Dear Clients, Thank you that you choose our built-in ovens. Before you start using them, please carefully read the following instructions. I.PURPOSE AND SCOPE OF USE The built-in ovens are designed for non-professional daily use, for heat treatment of food products. - Page 4 MODEL KO611TCBM KO608PBBM cl. I, cl. I, I. Electricity part 230V~ 50Hz 230V~ 50Hz 1 Power supply 5975 5975 2 Total power oven (W) 1300 1300 3 Upper heater (W) 1000 1000 4 Lower heater (W) 1700 1700 5 Infrared (W)
- Page 5 Fig 2 – model KO608PBBM Sensory zones for choice Combined indication for Sensory zones for choice and setting of functions functions and setting and setting of functions Fig 3 – model KO611TCBM...
-
Page 6: Installation
V. INSTALLATION ATTENTION! The installation of the oven, its connection to the power supply system, and the very first start of the oven in exploitation should be performed by authorized service (qualified technician). The installation is performed according to the requirements of the present instruction. ATTENTION Connection to the power supply system ... - Page 7 Observe the dimensions shown in the figure for installation. The bottom and top of the modules should always be shorter or have a notch in order to provide good ventilation. Level the kitchen module. The module, in which you install the built-in oven, should be firmly attached to the other modules.
- Page 8 VI.EXPLOITATION Use of the oven The oven is operated by two handles (buttons), which are located on the control panel. Use the button to select the mode and switch on the oven (the button can be rotated in both directions). Then, select the desired temperature using the other button. In case there is a mechanical timer, its management is performed by a third handle (button).
- Page 9 In spite of that we recommend you to open the window of the room for some fresh air. 2. We also recommend that the oven should run empty for at least 30 minutes. 3.The oven is not working without a temperature set by the thermostat. „Push-pull”...
-
Page 10: Cleaning And Maintenance
Never cover the oven or place pans on the bottom of the oven. This prevents the air circulation in the oven by slowing down the process of roasting and damages the enamel. Don’t use the oven to heat the rooms. ... - Page 11 The catalytic enamel is soft and sensitive to friction and therefore you should not use abrasive cleaners or sharp objects. Be very careful when installing and dismantling the cover, to avoid damage to the surface. The self-cleaning feature of the catalytic parts constantly decreases. We recommend you to replace the panels after several years' use.