ABB Excount II User Manual page 21

2. Connect the transceiver to the PC via the data cable. See also sec-
tion 2.6.4 for installation of USB drivers if this is the first time use
of the transceiver. Download the sensor's ID from the EXCOUNT-II
software into the Transceiver as described in the EXCOUNT-II help
system for Transfer data, see figure 2.7.3.
IMPORTANT! Check that the date and time on the Transcei-
ver are sychronized with the setting on the PC prior to trans-
fer, see figure 2.7.4 and 2.7.5. If not, set them as described
in section 5 of this manual. If this is not done the date stamp
from the sensor will be incorrect, which can lead to difficulties
in recording measurements.
Figure 2.7.3
Main menu
3. Before going to site, check the Transceiver's battery status. If
necessary, install a new battery as described in section 2.3.
4. Once at site, individually check that it is possible to make contact with
each sensor prior to installation, as described in section 2.4 e.
1HSA 801 080-15en EXCOUNT-II Users Manual
Figure 2.7.4
Windows date/time
properties menu
2. Before installation
Figure 2.7.5
Transceiver date/time
properties menu
21