Table of Contents
Advertisement
PREPARATION
• Take care to prevent infants from accidentally swallowing batteries.
• When not using the Remote Controller for an extended period, remove the batteries to
avoid possible leakage and damage to the unit.
• If leaking battery fl uid comes in contact with your skin, eyes, or mouth, immediately wash
with copious amounts of water, and consult your physician.
• Dead batteries should be removed immediately and disposed of properly, either in a battery
collection receptacle or to the appropriate authority.
• Do not attempt to recharge dry batteries.
Load Batteries (R03/LR03 × 2)
1
Press and slide the battery compartment lid on the
reverse side to open it.
Slide in the direction of the arrow while pressing the
2
Insert batteries.
Be sure to align the battery polarities (
3
Close the battery compartment lid.
Set the Current time
1
Press the "CLOCK ADJUST" button.
Use the tip of a ball-point pen or other small object to press the button.
2
Use the "TIMER SET (
clock to the current time.
button: Press to advance the time.
button: Press to reverse the time.
(Each time the buttons are pressed, the time will be advanced/reversed in
1-minute increments; hold the buttons depressed to change the time quickly
in 10-minutes increments.)
3
Press the "CLOCK ADJUST" button again.
This completes the time setting and starts the clock.
To Use the Remote Controller
● The Remote Controller must be pointed at signal receiver to operate correctly.
● Operating Range: About 5 m.
● When a signal is properly received by the air conditioner, a beeping sound will be
heard.
● If no beep is heard, press the Remote Controller button again.
Remote Controller Holder
Insert
Press in
Screws
1 Mount the Holder.
2 Set the Remote Controller.
CAUTION
mark.
) correctly.
/
)" buttons to adjust the
Slide up
Pull out
3 To remove the Remote Con-
troller (when use at hand).
Never mix new and used batteries, or bat-
teries of different types.
Batteries should last about 1 year under
normal use. If the Remote Controller's
operating range becomes appreciably re-
duced, replace the batteries and press the
"RESET" button with the tip of a ballpoint
pen or other small object.
En-4
Hide quick links:
Advertisement
Table of Contents
