Installer
Installer
Setup
Setup Name
Number
Temperature
0690
Control Cool
Recovery Heat
0685
Ramp Rate
Recovery Cool
0695
Ramp Rate
Temperature
0700
Display Offset
Restore Facto-
0710
ry Defaults
INSTALLER TESTS
Test 1
Installer Test Cool
Test 2
Installer Test Fan
Test 3
Installer Test Heat
Installer Test Auxil-
Test 4
iary Heat
Installer Test TOD/
Test 8
Economizer
NOTE: Press the Done button to exit the Installer System Test.
Table 3 − Installer Setup Menu (Continued)
Default
All Settings
Setting
1−Less Aggressive
2−Standard
2
3−More Aggressive
5
0−20°F/hour
3
0−20°F/hour
−3 (−1.5) −3°F(−1.5°C)
−2 (−1.0)− −2°F (−
1.0°C)
−1 (−0.5)− −1°F
(−0.5°C)
0
0 (0.0)−0°F (0.0°C)
1 (0.5)−1°F (0.5°C)
2 (1.0)− 2°F (1.0°C)
3 (1.5)−3°F (1.5°C)
0 −No
0
1−Yes
0
0
0
0
0
Only shown if system has cool stages.
Only integral gains affected. Affects control op-
eration in all control regimes (not just recovery
or setpoint change).
More Aggressive stops signal prior to reaching
the setpoint. (For use with oversized equip-
ment.)
Only shown if system has heat stages.
0 disables ramped recovery (step setpoint
change at period start time).
Only shown if system has cool stages.
0 disables ramped recovery (step setpoint
change at period start time).
This offset applies to both the control tempera-
ture and to the display temperature for indoor
sensor (and remote indoor sensor).
Resets all ISU parameters to default values and
resets the schedule to default Energy Star. Re-
tains only calendar settings and time.
0−Off
1−Cool Stage 1
2−Cool Stage 2
0−Off
1−Fan On
0−Off
1−Heat Stage 1
2−Heat Stage 1 and 2
3− Heat Stage 1, 2 and 3
0−Auxiliary Heat Off
1−Auxiliary Heat On
0−TOD/Economizer Off
1−TOD/Economizer On
Page 11
Notes