If you do not hear any beep after having inserted the battery, remove it immediately from its
housing. Check the polarity before trying again.
Before putting the lid back in place, check that the rubber seal is in its groove. Make sure the tab is
▪
in correct position (inside the battery housing) to maintain water tightness.
Screw up the 4 screws with care (do not overtighten them).
▪
Polarity « - » of the
battery
Activate/deactivate the remote control
Remote control is supplied with battery fitted.
Activate: press the On/Off red button ( ) located on the side of the remote control for 1
▪
second (ref. Diagram.1). Indications appear on the LCD screen.
Deactivate: press the On/Off red button ( ) of the remote control for 1 second (ref.
▪
Diagram.1). The LCD screen is off.
To increase the battery life of the remote control, we recommend you to deactivate the unit if you are not
using it for a long period.
Activate/deactivate the receiver collar
A magnet located in the remote control is used to either switch on/off the receiver collar.
Activate: approach the red mark located on the remote control until coming in contact on red mark
▪
located on the receiver collar for 1 second (ref. Diagram 5). The indicator light on the collar will
flash in green indicating that the CANICOM receiver is ready.
Deactivate: approach the red mark located on the remote control until coming in contact on red
▪
mark located on the receiver for 1 second (ref. Diagram 5). The indicator light on the collar will
flash from green to red and then off: the CANICOM receiver is off.
To increase the battery life of the receiver collar, we recommend you to deactivate the unit if you are not
using it for a long period.
REMOTE
CONTROL
CANICOM 200 – User's guide – indice C
Polarity « + » of the
battery
Diagram 4
Approach until coming in contact those 2
areas during 1 second
RECEIVER
COLLAR
Seal
Diagram
5
5/12
Need help?
Do you have a question about the CANICOM 200 and is the answer not in the manual?