Table of Contents
Advertisement
2
Connect a regular telephone instrument to the port marked
"Phone" using a RJ11 phone cable.
3
Connect computers using RJ45 cables. Plug one end of
the RJ45 cable to the Ethernet port of PC/Lap Top and the
other end to any one of the CPE RJ45 ports marked from
"LAN1" to "LAN4".
4
If users have subscribed to VoIP service, the green VoIP
Ready LED should light after power on. This indicates that
VoIP service is available and ready for use. Users may
have to wait for several minutes.
5
NetSprite1023 has a built-in WLAN card. Users may install
a wireless card for each PC and set up wireless LAN
(WLAN).
6
Power connection: Plug the AC/DC power converter to an
AC wall socket and the other end of the cable to the device
socket marked "POWER".
Chapter 2 Installation Planning
13
13
Advertisement
Table of Contents
