Compressor Repair - Graco 231–323 Instructions-Parts List Manual

WARNING
HOT SURFACE HAZARD
Be sure the compressor duct work is
cool before removing it. If the sprayer
was operated recently, it will be very hot
and can cause burns!
NOTE: Clean the cooler whenever the compressor is
serviced.
NOTE: A compressor rebuild kit is available; see
manual 308–185. The kit includes instructions. For
repair assistance or for compressor service center
locations, call your local Graco distributor or
1-800-888-2468.
1. Follow the Pressure Relief Procedure. See page
2.
2. Remove the hopper. See page 5.
A
57
26B
35
Fig. 16
16 308–342

Compressor Repair

26A
3. Disconnect the pump ground wire (57) at A.
Remove the two front screws (26A) and loosen the
two rear screws (26B). Move the pump (35) out of
the way.
4. Remove the air filter (21).
5. Remove the three screws (17A). Pull the cover
(23) straight out.
6. Pull the bracket (22) up and off.
7. Remove the two screws (17B) and the four screws
(17C). Remove the shroud (B).
8. If you are only rebuilding the compressor (48), see
manual 308–185. Clean the air filter (21) and
reassemble the unit.
NOTE: To remove the compressor, continue on page
17.
48
17C
23
17A
B
17B
22
21
05522