Hyundai Sonata 2017 Owner's Manual page 294

Multimedia System
V V O O I I C C E E R R E E C C O O G G N N I I T T I I O O N N
Using Voice Recognition
Starting Voice Recognition
Shortly press the key on the
steering wheel. Say a command.
If prompt feedback is in [ON], then
the system will say "Please say a
command after the beep (BEEP)"
• If prompt feedback is in [OFF]
mode, then the system will only
say "(BEEP)"
• To change Prompt Feedback
[On]/[Off], go to
SETUP
[Prompt Feedback]
4-46
i
Information
For proper recognition, say the com-
mand after the voice instruction and
beep tone.
Contact List Best Practices
1) Do not store single-name entries
(e.g., "Bob", "Mom", "Kim", etc.).
Instead, always use full names
(including first and last names) for
all contacts (e.g., use "Jacob
Stevenson" instead of "Dad").
2) Do not use abbreviations (i.e., use
"Lieutenant" instead of "Lt." or
"Sergeant" instead of "Sgt.").
3) Do not use acronyms (i.e., use
"County Finance Department"
instead of "CFD").
4) Do not use special characters
(e.g., "@", "hyphen -", "asterisk *",
"ampersand &").
5) If a name is not recognized from
the contact list, change it to a
[System]
more descriptive name (e.g., use
"Grandpa Joseph" instead of "Pa
Joe").
Skipping Prompt Messages
While prompt message is being stat-
ed Shortly press the key on the
steering remote controller
The prompt message is immediately
ended and the beep tone will sound.
After the "beep", say the voice com-
mand.
Re-starting Voice Recognition
While system waits for a command
Shortly press the key on the
steering remote controller
The command wait state is immedi-
ately ended and the beep tone will
sound. After the "beep", say the voice
command.