Hyundai Sonata 2017 Owner's Manual page 116

Flashing
2. Position the end of your hand-held
transmitter 1-3 inches (2-8 cm)
away from the HomeLink
you wish to program while keeping
the indicator light in view.
3. Simultaneously press and hold
both the HomeLink ® and hand-
held transmitter buttons until the
HomeLink ® indicator light changes
from a slow to a rapid blinking
light. Now you may release both
the HomeLink ® and hand-held
transmitter buttons.
i
Information
Some devices may require you to
replace this Programming step 3 with
procedures noted in the "Gate
Operator/Canadian Programming"
chapter. If the HomeLink
light does not change to a rapidly
blinking light after performing these
steps, contact
www.homelink.com.
ODH044414N
®
button
4. Firmly press, hold for 5 seconds and
release
HomeLink
rate times to activate the door. If the
door does not activate, press and
hold the just-trained HomeLink
®
indicator
ton and observe the indicator light.
• If the indicator light stays on con-
stantly, programming is complete
®
HomeLink at
and your device should activate
when the HomeLink
pressed and released.
• If the indicator light blinks rapidly
for 2 seconds and then turns to a
constant light, continue with
"Programming" steps 5-7 to com-
plete the programming of a rolling
code equipped device (most com-
monly a garage door opener).
5. At the garage door opener receiv-
er (motor-head unit) in the garage,
locate the "learn" or "smart" but-
ton. This can usually be found
where the hanging antenna wire is
attached to the motor-head unit.
the programmed
® button up to two sepa-
®
but-
® button is
3-31
3