Hyundai Sonata 2017 Owner's Manual page 124

5. Press and hold the just-trained
HomeLink ® button and observe
the red Status Indicator LED. If the
indicator light stays on constantly,
programming is complete and
your device should activate when
®
the HomeLink button is pressed
and released.
6. To program the remaining two
HomeLink ® buttons, follow steps 2
through 5.
Gate operator & Canadian program-
ming
During programming, your handheld
transmitter may automatically stop
transmitting. Continue to press the
Integrated HomeLink ®
Control System button
steps 2 through 4 in the Standard
Programming portion of this docu-
ment) while you press and re-press
("cycle") your handheld transmitter
every two seconds until the frequen-
cy signal has been learned. The indi-
cator light will flash slowly and then
rapidly after several seconds upon
successful training.
®
Operating HomeLink
To operate, simply press and release
the programmed HomeLink
Activation will now occur for the
trained device (i.e. garage door
opener, gate operator, security sys-
tem, entry door lock, home/office
lighting, etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time.
Reprogramming a single
®
HomeLink button
To program a new device to a previ-
ously trained HomeLink
low these steps:
Wireless
1. Press and hold the desired
(note
HomeLink ®
release until step 4 has been com-
pleted.
2. When the indicator light begins to
flash slowly (after 20 seconds),
position the handheld transmitter 1
to 3 inches away from the
®
HomeLink
3. Press and hold the handheld
transmitter button. The HomeLink
indicator light will flash, first slowly
and then rapidly.
4. When the indicator light begins to
® button.
flash rapidly, release both buttons.
5. Press and hold the just-trained
HomeLink ®
the red Status Indicator LED. If the
indicator light stays on constantly,
programming is complete and
your new device should activate.
® button, fol-
button. Do NOT
3
surface.
®
button and observe
3-39