Parts Diagram - WeatherTech AlloyCover Installation Instructions And Owner's Manual

PREPARATION
Unpack cover components and clean truck box if dirty.
COMPONENTS:
(1) Driver side rail
(1) Passenger side rail
(8) Clamps
(1) Pre-folded cover assembly
NOTE ON BED LINERS: With an under-the-rail drop-in bed liner, installation is possible
with minimal trim/cutting of bed liner at front corner of box and back by tailgate to allow
side rail to install properly. Considerable trim/cutting is required with an over-the-rail
drop-in bed liner.
NOTE: For additional protection against the elements, locate and seal miscellaneous
factory holes, crevices, stake pockets, etc. that may be on box (sealant not included).
NOTE: Rails may be contoured to follow the shape of the box.

PARTS DIAGRAM

Front of cover (closest to
cab) has storage
clip retainers
Front catch
towards front of box
Left side rail
Rail clamps
TOOLS NEEDED:
- 1/2" wrench
- Torque wrench with 1/2" socket
- Spring clamp - optional
- Tape measure or ruler
- Protective eyewear
- Marking pen
Latch on rear
panel
2
Cover assembly
Right
side rail