Figure 11: Rotate The Transmitter - Honeywell SLG 700 Quick Start Manual

Step
Transmitters with threaded process connectors can be screwed to
tanks or nozzles with threaded bosses. For tanks with BSP/G
1 threads, place a gasket on top of the tank, or use a sealant on the
threads of the tank connection.
The transmitter must be tightened to the appropriate torque setting. After this is
complete, the sensor and transmitter electronics housings can be rotated to the
relevant position. Loosen lower two set screws to rotate, see
Product damage can occur if the joint between the sensor and the
electronics housing is rotated. See
20

Figure 11: Rotate the transmitter

Quick Start Installation Guide
Action
Figure 11.
for details.
Figure 1
December 2017