Honeywell SLG 700 Quick Start Manual page 11

Install the rod end segment by repeating Step 2 and 3. Then use
a tube coupler to attach the tube end segment. Insert 2 M3 set
screws into each coupler.
Note: Tighten M3 set screws to the 1.0Nm (8.8in-lb).
7
It is recommended that a process compatible thread locking
compound (i.e. Loctite 242) be used on each set screw.
Insert and end spacer into the end of the tube. Align the holes in
the end spacer with the holes in the outer tube and insert the 2
8
locking pins. Refer to Detail B of
December 2017 Quick Start Installation Guide
Figure 5.
11