Voice Recognition (Vr) - Toyota Bluetooth SWC Owner's Manual

5. Voice Recognition (VR)

Your hands-free system uses menu-driven voice recognition (VR) for setup and
operation.
Pressing and holding the Mode button activates a VR session with your hands-free
system.
VR has two main menus:
— main phone/setup menu — available except when in a call
— call menu — available when a call is active.
When you begin a VR session, you'll hear a prompt and then a short beep. This short
beep - also known as a listening prompt - indicates that the hands-free system is
waiting for a verbal command from you.
Depending on which menu you are in, saying the predefined commands allows you to
operate the hands-free system.
ó
Note: Some helpful tips during a VR session:
— VR includes help prompts in every menu. While learning to use the hands-free
system, or whenever you need a reminder of the command list, say Help. For some
menus, you can also say Additional Help
— to repeat a prompt for a Yes or No question, say Repeat. The hands-free system will
repeat the question
— to immediately stop a prompt, press and hold the Mode button. The hands-free
system returns to the listening prompt
— to return to the previous menu, say Cancel
— to exit the VR session, say Exit or press the Seek down button
— to increase/decrease the VR session volume by a single level, press the Volume Up or
Volume Down button
ó
Note: Tones are played to indicate when the maximum and minimum volumes are
reached.
12 Bluetooth® SWC
A