Dometic MS680 Installation And Operating Manual page 19

MS680
9.2 Programming (optional)
You can program the functions listed in the following table. These functions remain
stored even if the battery is disconnected.
To program a function, proceed as follows:
➤ Start the ignition with the alarm system deactivated.
✓ The LED in the base of the electronic key illuminates for two seconds.
➤ Insert the electronic key into the key holder within these two seconds.
✓ To indicate that the programming mode has been activated, the LED flashes
three times and the siren emits three acoustic signals.
✓ The first function is activated.
I
NOTE
Each time you call up the programming mode in this way, all the values
of the individual functions are reset to the factory settings (see following
table).
Function
Optical signals
during activation/
deactivation
Acoustic signals
Passive alarm
EN
Factory
LED
setting
Off Flashes once
Off Flashes twice The following acoustic signals are
Off Flashes three
times
Programming the alarm system
Programming
This function can only be activated for
vehicles which do not emit any
optical signals (e.g. indicator) during
opening or closing.
emitted:
Activating: 2 signals
Deactivating: 1 long signal
Deactivating when the alarm has
been triggered: 1 brief signal
This function automatically activates
the alarm system 60 seconds after the
ignition has been switched off.
When this function is activated, the
convenience output and the ultra-
sonic sensors are deactivated.
17