Dometic MS680 Installation And Operating Manual page 15

MS680
No.
10
11
12
13
All plugs are coded so that you cannot connect them incorrectly.
8.1 Connecting the connection wires of the connection
cable (fig. 9)
Connecting the siren
➤ Insert the plug of the connection cable (fig. 9 11) into the connection of the
ultrasonic module.
➤ Guide this open cable end through the splash-protection wall into the passenger
compartment.
➤ Connect the red cable of the siren to the red cable of PIN 3 (8-pin plug of the
connection cable on the MS680 control unit) (fig. 9 10).
➤ Connect the blue cable of the siren to the blue/brown cable of PIN 18 (20-pin
plug of the connection cable on the MS680 control unit) (fig. 9 1).
➤ Connect the grey cable to the grey cable of PIN 15 (20-pin plug of the
connection cable on the MS680 control unit) (fig. 9 1).
➤ Connect the black cable to the black cable of PIN 1 (8-pin plug of the connection
cable on the MS680 control unit) (fig. 9 10).
Connecting the electronic key base
➤ Plug the red two-pin connector of the electronic key base (fig. 1 6) into the red
socket of the connection cable.
➤ Plug the white two-pin connector of the electronic key base (fig. 1 6) into the
white socket of the connection cable.
Violet (ignition plus)
➤ Connect the violet cable of PIN 10 (20-pin plug of the connection cable)
(fig. 9 1) to PIN 16 (20-pin black plug of the vehicle fuse box) (fig. 9 9).
EN
Description
8-pin plug of the connection cable on the MS680 control unit
Siren
Bonnet switch
Power supply connection
Connecting the alarm system electrically
13