Huawei OptiX OSN 550 Configuration Manual page 113

OptiX OSN 550 Multi-Service CPE Optical Transmission
System
Configuration Guide
3.
Issue 02 (2011-06-30)
Parameter Value in
This
Example
Source Slot 1-SL1D-2
(SDH-2)
Source VC4 VC4-1
Source 1-5
Timeslot
Range(e.g.
1,3-6)
Sink Slot 1-SL1D-1
(SDH-1)
Sink VC4 VC4-1
Sink 1-5
Timeslot
Range(e.g.
1,3-6)
Activate Yes
Immediately
Configure SDH services on the sink NE (NE3).
Click , and select NE2 from the displayed NE Navigator. Click OK.
Parameter Value in
This
Example
Level VC12
Direction Unidirection
al
Source Slot 1-SL1D-2
(SDH-2)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Description
In this example, the SL1D board in slot 1 is configured
as the source line board. See
different source boards depending on the actual
situation.
In this example, the services require five VC-12s.
Source VC4 is set to VC4-1, because a VC-4 contains
63 VC-12s.
The total capacity of the services is 5xE1 according to
the plan. Hence, Source Timeslot Range(e.g.1,3-6) is
set to 1-5.
In this example, the SL1D board in slot 1 is configured
as the sink line board. See
In this example, the services require five VC-12s. Sink
VC4 is set to VC4-1, because a VC-4 contains 63
VC-12s.
The total capacity of the services is 5xE1 according to
the plan. Hence, Sink Timeslot Range(e.g.1,3-6) is set
to 1-5.
-
Description
In this example, E1 services are configured. Hence,
Level of the E1 services is set to VC12.
In this example, the services are transmitted and received
on different paths. That is, the services are unidirectional
services. Hence, Direction of the services is set to
Unidirectional.
In this example, the SL1D board in slot 1 is configured
as the source line board. See
3 Configuring SDH Services
Figure 3-10. You can select
Figure 3-10.
Figure 3-10.
3-31