Determining The 4-Digit Code - Radio Shack 4-in-One Smart Light-Up Remote Control Owner's Manual

15-1993.fm Page 15 Wednesday, October 20, 1999 12:03 PM
If necessary, repeat these steps for each de-
vice.
Note: Some VCRs and CD players do not have
a POWER key on the original remote. If so,
manually turn on the VCR, insert a tape or CD,
and repeat the manual code search using
instead of . When the device responds,
POWER
press . The red light blinks twice.
P

Determining the 4-Digit Code

After you set up your remote control using the
manual code search, you can find which 4-digit
code the remote control is set to by following
these steps.
1. Press the device key you want to get the
manufacturer's code from, then hold down
until the red light blinks twice.
P
2. Press . The red light blinks twice
9 9 0
again.
3. Press , then count the number of times
1
the red light blinks. This is the first digit of
the 4-digit code.
Note: If the red light does not blink, the
digit is a .
0
4. Repeat Step 3 three times to find the sec-
ond, third, and fourth numbers of the 4-
digit manufacturer's code, pressing
and respectively for each additional digit.
4
15
PLAY
, ,
2 3