Table of Contents
Advertisement
long as it has been set up as a television, VCR, cable
box, or satellite receiver).
Important: If you program Favorite Channel Scan, you
can no longer use
SCAN
Channel Scan" on Page 37). If you want to use the re-
mote for Channel Scan after you have programmed it for
Favorite Channel Scan, you must reset the entire opera-
tion of the remote (see "Using Operation Reset" on
Page 44). You lose all stored information.
Note: If no key is pressed for 60 seconds, the remote
control automatically exits setup.
the remote returns to the previous mode screen.
Follow these steps to program Favorite Channel Scan.
1. Hold down
for at least 3 seconds.
P
appears.
Note: To exit setup, hold down
;N?J?D=
;N?J?D=
;N?J?D=
;N?J?D=
seconds.
screen.
2. Touch the up arrow twice.
Note: If you scroll past
arrow to return to it.
3. Touch
. The last selected mode appears.
SELECT
4. Touch a device key (
,
, or
AUX 2
AUX 3
appears.
;DJý9>7D
;DJý9>7D
;DJý9>7D
;DJý9>7D
5. Touch
.
SELECT
6. Enter a favorite channel by touching the corre-
sponding numbers on the keypad. To accept the
entry, touch
SELECT
Note: A channel number can be up to four digits (for
example, 2, 13, 132, or 1024).
7. Repeat Step 6 up to nine more times to enter other
favorite channels for the same device.
for Channel Scan (see "Using
;N?J?D=
;N?J?D=
;N?J?D=
;N?J?D=
again for at least 3
P
appears, then the last-used mode
<7Lý9>7D
<7Lý9>7D
<7Lý9>7D
<7Lý9>7D
appears.
<7Lý 9>7D
<7Lý 9>7D
<7Lý 9>7D
<7Lý 9>7D
, touch the down
,
,
TV
VCR/DVD
CAB/SAT
). The selected mode
AUX 4
appears.
;DJý9>7D
;DJý9>7D
;DJý9>7D
;DJý9>7D
.
appears.
Preparation
appears, and
9E:;ý I;J
9E:;ý I;J
9E:;ý I;J
9E:;ý I;J
,
,
AUX 1
27
Advertisement
Table of Contents
