Axis Travel Limits (Software Limits) - Fagor CNC 8055i FL EN Installation Manual

Cnc 8055 series

Table of Contents

Axis travel limits (software limits)

Once all the axes have been referenced, their software limits must be measured and set.

This operation must be carried out one axis at a time and it could be done as follows:

• Move the axis in the positive direction towards the end of the axis travel stopping at a safe

distance from the mechanical end-of-travel stop.

• Assign the coordinate shown by the CNC for that point to axis parameter LIMIT+ (P5).

• Repeat these steps in the negative direction assigning the resulting coordinate to axis parameter

LIMIT- (P6).

• Once both travel limits have been set for all the axes, press SHIFT + RESET or turn the CNC

OFF and back ON in order for these new values to be assumed by the CNC.

I n st a l l a t io n ma n u a l

Do you have a question about the CNC 8055i FL EN and is the answer not in the manual?