Table Of Contents - Onkyo TX-NR929 Service Manual

DEBUG MODE-1
AUDIO DEBUG MODE-1/4
AUDIO DEBUG MODE (Display mode of the audio information)
The operations of DSP and DIR etc are able to checked by the information displayed on FL in this debug mode.
This information will help to analysing digital audio no sound trouble.
To set in Debug mode
1. Press twice the ON/STANDBY key while pressing the DISPLAY key.
e.g.
2. Press +(TONE) button while the version number of microprocessor is displayed.
e.g.
3. Press DISPLAY button while the version number of DSP is displayed.
e.g.
0A0002 :
ANA : o : NON :
4. Press DISPLAY button.
e.g.
1 : ANA 0 48k0 48k
2 / 0 . 0 : 2 . 0 : 3 / 4
5. Press DISPLAY button.
e.g.
2 : o : PCM : PCM
00 : x: F: OF F
6. Press DISPLAY button.
e.g.
SP00F 00 F004 09
*
48 48256S T B
7. Press DISPLAY button.
e.g.
L : 0 0
R : 0 0
8. Press DISPLAY button.
e.g.
C : 0 0
9. Press DISPLAY button.
e.g.
LS : 0
R S : 0
M ai n:
1. 01 / 135 15A E 8
DSP 1st / NE T:
1. 07 / 135 14A E A
: 0 0 Audio dubug mode
Step-1
:
Step-2
Step-3
Step-4
Step-5
Step-6
Step-7
0
0
TX-NR828/ 929/ DTR-50.5/ 60.5/ DHC-60.5
The version number of microprocessor is displayed
only for 3 seconds.
The version number of DSP is displayed
only for 3 seconds.
10. Press DISPLAY button.
e.g.
L B : 0 0
R B : 0 0
11. Press DISPLAY button.
e.g.
L H : 0 0
R H : 0 0
12. Press DISPLAY button.
e.g.
L W : 0 0
R W : 0 0
13. Press DISPLAY button.
e.g.
S W : 0 0
S W2 : 0 0
14. Press DISPLAY button.
Exit
Step-8
Step-9
Step-10
Step-11