Test Mode - Onkyo TX-NR929 Service Manual

OPERATION CHECK-6
3.INITIAL SETTING FOR SHIPPING
a. Initialization of memories.
Press ON/STANDBY button while pressing down CBL/SAT button when the unit is POWER ON, then the FLT displays
"CLEAR", and turn to STAND-BY. Remove power cord from power line.
b. (Please pull out the AC cord at the standby mode.)

4.TEST MODE

4-1 TEST MODE FOR FL DISPLAY
a. Push ON/STANDBY key while pushing down TV/CD button button to display "TEST-".
b. Then push DIMMER (or RT/PTY/TP) button and get the FL test mode.
c. In the FL test mode, TONE - button is FL TEST UP and TONE + button is FL TEST DOWN.
d. REC OUT and ZONE2 button's originally operation can't work when it is in FL test mode.
e. The contents of the step are as follows.
1. Lit all segment
2. Lit upper 'EDCBA987654321', lower '23456789ABCDEF'.
3. Lit a even number segment
4. Lit an odd number segment
5. The Destination is displayed.
Please see the below for detail.
To close the FL test, push ON/STANDBY button.
Display of Destination on TEST MODE.
N R 9 2 9
MODEL Name
TX-NR929: NR929
DTR-60.5: DTR605
DHC-60.5: DHC605
MODEL Name
Destination Dx
ABCD
2400
MODEL Name
Destination
ABCD
NOTE : If VOL value is not 30 (-52dB) (initial setting), test mode cannot be set.
D
Destination
Dx: USA
xx: OTHER
JJ: JAPAN
NR929 DTR605
xx JJ Dx
MA
MB
MP
MR
8400 4400 2460
DHC605
Dx
2480
TX-NR929/ DTR-60.5/ DHC-60.5
2 0 0 0
A B C D
A: Value of AD port of BAND
B: Value of AD port of INIT1
C: Value of AD port of INIT2
D: Value of AD port of INIT3
xx JJ
MA
MR
8460 4460