Provisioning Device; Agency Compliance Information; Fcc Compliance Statements; Ic Compliance Statements - Honeywell OWA 100 OneWireless User Manual

For detailed OWA 100 Adapter specifications see the following Specification and Model Selection Guide.

OWA 100 Adapter (document 34-XY-03-43)

Provisioning Device

Install the Provisioning Device application on any PDA having

Windows Mobile version 4.2+

Infrared port.
2.3

Agency compliance information

This section contains the Federal Communications Commission (FCC), Industry Canada (IC) and Radio
Frequency compliance statements for the OneWireless Multinode device.
ATTENTION
OWA 100 ADAPTER 100 units must be professionally installed in accordance
with the requirements specified in the OneWireless Agency Compliance
Professional Installation Guide.

FCC compliance statements


This device complies with Part 15 of FCC Rules and Regulations. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference and (2) this device must
accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radiofrequency energy and, if not installed and used in accordance with these instructions, may
cause harmful interference to radio communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be required to correct the interference
at his own expense.

Intentional or unintentional changes or modifications must not be made to the Multinode unless under
the express consent of the party responsible for compliance. Any such modifications could void the
user's authority to operate the equipment and will void the manufacturer's warranty.

IC compliance statements


To reduce potential radio interference to other users, the antenna type and its gain should be so chosen
that the equivalent isotropic radiated power (EIRP) is not more than that permitted for successful
communication.

Operation is subject to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation
of the device.

This Class A digital apparatus complies with Canadian ICES-003.

French: Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
Rev. 1
September 2010
OWA 100 Adapter User Manual
2. Specifications
2.3. Agency compliance information
5