Replacing V-Nail Driver - Grizzly T27577 Owner's Manual

Replacing V-Nail
Driver
The V-nail driver will eventually require replace-
ment due to normal wear and tear as the machine
is used. The V-nail driver may need replacing
if V-nails easily jam in V-nail block, or if driver
becomes jammed inside V-nail block channel,
which signals driver is worn. Because the V-nail
driver is considered to be a wear item, normal
wear and tear is not covered under warranty. It
is important to keep the V-nail driver and V-nail
block clear of debris and adhesive buildup to pro-
long its life.
Tools Needed
Open-End Wrench 8mm.................................... 1
Hex Wrench 3mm .............................................. 1
Magnetic Pen Tool ............................................. 1
To replace V-nail driver:
1. Loosen cap screw securing V-nail driver (see
Figure 28).
Cap Screw
Figure 28. Location of cap screw that secures
V-nail driver assembly.
2. Loosen hex bolt securing V-nail block, and
remove block from work table.
V-nail
Block
Figure 29. Removing V-nail block.
-18-
3.
4.
5.
Qty
V-Nail
Driver
6.
7.
Hex Bolt
Move vertical clamp aside, and lower pres-
sure pad all the way down.
Press foot pedal. Vertical clamp will contact
work table and driver will move into view.
Remove old driver and install new driver.
IMPORTANT: Ensure driver orientation is
correct. V-shape lip must point toward center
of V-nail block (see Figure 31).
Driver
Figure 30. Removing driver from work table.
Driver
Figure 31. Driver orientation in V-nail block.
Press driver into place and tighten cap screw.
Re-insert V-nail block and tighten hex bolt.
Model T27577 (Mfd. Since 3/16)
V-Nail
Block
V-Nail
Block