Inventory - Grizzly T27577 Owner's Manual

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
A
D
G
-8-

Inventory

C
E
H
Figure 3. Model T27577 inventory.
Inventory (Figure 3):
A. Extension Tables ........................................ 2
B. Tool Tray ..................................................... 1
C. Rubber Feet ............................................... 4
D. Vertical Clamp Assembly ........................... 1
E. Magnetic Tool ............................................. 1
F. Angle Inserts: 120° & 135° ...................1 Ea.
G. Pressure Pad: Round & 90° .................1 Ea.
H. Front Clamp ................................................ 1
I. Open-End Wrench 8/10mm ........................ 1
J. Hex Wrench Set: 2.5, 3, 4, 5, 6mm ......1 Ea.
K. Hardware (not shown)
—Cap Screws M6-1 x 10 ......................... 10
—Flat Washers 6mm ............................... 10
A
I
J
Model T27577 (Mfd. Since 3/16)
Qty
B
F