Table of Contents
Advertisement
SECTION 3: OPERATIONS
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual, seek additional training from experienced
machine operators, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire
using machine.
Eye injury hazard! Always
wear safety glasses when
using this machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
Model T27577 (Mfd. Since 3/16)
manual
BEFORE
To complete a typical operation, operator
does the following:
1.
Examines workpiece components to make
sure they are suitable for framing.
2.
Attaches appropriate pressure pad (90° or
round) to bottom of pressure bar.
3.
Adjusts fence and fence stops to align frame
corner with pressure bar and V-nail insertion
location.
4.
Adjusts V-nail height dial to accommodate
workpiece.
5.
Chooses number and size of V-nails to be
inserted.
6.
Positions workpiece into clamping area,
securing front clamp placement using clamp
pedal to apply pressure.
7.
Adjusts height of pressure pad above
workpiece.
8.
Presses down on pressure bar foot pedal
until indicator light illuminates.
9.
Releases pressure bar foot pedal, and press-
es down on clamp pedal to release workpiece.
-11-
Advertisement
Table of Contents
