HoMedics BPW-360BT Manual page 11

1. W hile the screen is dark, press and hold the MEM
button for 3 seconds to choose User 1 or User 2.
The display will show the blinking User icon. Pressing
the MEM button again will toggle between the two
users in a cycling manner. Press the SET button to
confirm the entry and the User icon will stop blinking.
2. With the cuff wrapped around your wrist, press the
START/STOP button. Do not inflate the cuff unless
it is wrapped around your wrist. All digits will light
up, checking the display functions. The checking
procedure will be completed after about 3 seconds.
MEMORY REVIEW
START
STOP
MEMORY REVIEW
LAST 3 AVG.
3. After all symbols disappear, the display will show "0".
The monitor is "Ready to Measure" and will
automatically inflate the cuff to begin measurement.
MEMORY REVIEW
MEMORY REVIEW
LAST 3 AVG.
19
4. When the measurement is completed, the cuff
will deflate entirely and systolic pressure, diastolic
pressure and pulse will be shown simultaneously
on the LCD screen. The measurement is then
MEMORY REVIEW
MEMORY REVIEW automatically stored into memory and will
attempt to connect and send the measurement
result to your mobile device.
MEMORY REVIEW
LAST 3 AVG.
Note:
• T his monitor automatically turns off approximately
1 minute after last operation. You may also press the
START/STOP button to turn the unit off.
• A t the conclusion of data transmitting, the screen will
display the following:
• If the transmission was successful, the
Data transmission indicator
will be displayed on the screen.
• If the transmission was unsuccessful, the
Data transmission indicator
icon will be displayed on the screen.
20
and "done"
and the