Chapter 1: Product Overview; Battery Installation; Access To The Wi-Fi Network; Handset And Charger - Cisco Linksys WIP310 User Manual

Wireless-g ip phone
Table of Contents

Advertisement

Chapter1
Chapter :
Product Overvew

Battery Installation

Open the handset's back battery cover and place the
battery so that the metal contacts on the battery touch
the metal contacts in the battery compartment . Replace
the cover after the battery is installed .
Battery Installed

Access to the Wi-Fi Network

The Wireless-G IP Phone requires a wireless connection to
a Wi-Fi network to operate . The network must also have an
internet connection to make VoIP calls .
You can configure the phone to connect to a specific
wireless network or search for "open" networks . Wireless
network information is stored in the phone's memory as
"Preferred Networks" that are searched for each time the
phone is powered on .
When powering on the Wireless-G IP Phone for the first
time, after charging the phone, there are no Preferred
Networks in the phone's memory . You need to select a
wireless network and sign in before you can make calls .
The information that follows assumes that you already
have an established Wi-Fi network . If you need more
information on networks, visit www .linksys .com .
NOTE:
The handset should be within 300 feet
(90 m) of the Network to connect .
Wireless-G IP Phone

Handset and Charger

Handset in charger
Charging the Handset's Battery
Plugging in the Power Adapter
Plug the power adapter into the charger and then plug
the adapter into a wall outlet . Place the handset into the
charger . The handset requires an initial eight hour charge .
Powering On the Handset
Power on the handset by pressing and holding the
Power/End call key until you see LINKSYS on the screen .
The handset will finish powering up and finding the base .
It is ready to use when it is in the standby mode .
Talk time for the handset is approximately three (3) hours
and standby time is approximately 50 hours . Linksys
recommends that you keep the handset in the charger,
when it is not in use .
Powering Off the Handset
Power off the handset by pressing and holding the Power/
End call key until you see LINKSYS on the screen .
Handset Keys and Buttons
Product Overview


Advertisement

Table of Contents
loading

Table of Contents