Rain Bird ESP-MC Installation And Operating Instructions Manual page 16

Setting a cyclical cycle:
7. Return the dial to AUTO. The controller re-
turns to the time of day display and waters
on the days you have specified.
To set an odd or even cycle:
1. Rotate the dial to ODD DAYS or EVEN
DAYS. The display shows the program and
ODD or EVEN. The display shows USED if
the program is active and using a different
cycle mode. If this is the case, you can over-
ride the previous setting.
2. If the program you want is not displayed,
press PGM until it is.
3. Press ON. The display shows either ODD or
EVEN and the corresponding light on the
faceplate illuminates.
4. Return the dial to AUTO. The controller re-
turns to the time of day display and waters
on the days you have specified.
Note: The 31st day of the month defaults to ON,
so if you do not want to water on the 31st, you
must set that day to OFF.
Step three:
Setting the length of a station's watering time
Within the program you are setting, you can set
the length of a station's watering time from 0 min-
utes to 12 hours. Set the time in one-minute in-
crements for up to two hours; set it in 10-minute
increments from two hours to 12 hours.
To set the length of a station's watering time,
1. Rotate the dial to STATION WATERING
TIME. The display shows the program, the
station number, and the length of watering
time. The station number is flashing, indicat-
ing that it is ready to be set. If the station is
included in any other program, the controller
will let you know by replacing the length of
watering time with USED.
2. If the program you want is not displayed,
press PGM until it is.
(Continued)
16
A
PGM
A
PGM
WATER TIME
STATION