Sanyo POA-SP-SU31 Service Manual page 6

Mechanical disassemblies
3.
CABINET FRONT REMOVAL.
Remove 3 screws which are fixing a Front Panel.
Two projections fixing hock the front panel are provided
on the inside of the bottom surface of the Smoke
Resistant Unit both at distances of 136mm from the
sides of the unit. Pull the front panel towards yourself in
a directions at which the projections are located
upwards from below, so as to remove the front panel.
CAUTION:
Do not tilt the front panel when pulling it to remove
it, as this may damage the projections which will
make it impossible to put the front panel back on
again.
4.
COVER DUCT-A REMOVAL.
Remove 3 screws, and remove Cover Duct-A.
Note;
In to exchange this cover duct for th cover duct of the
accessory,
MODEL No. : POA-SP-SU31
LCD Projector of LP-SU30/XU30/XU35 can be used.
MODEL No. : POA-SP-SU30
LCD Projector of LP-SU31/XU31,LP-SU32/XU32/XU37,
LP-SU33/XU33/XU38 can be used.
Refer to Owner's Manual.
COVER DUCT-A
- 6 -
CABINET FRONT
136mm
HOOK
136mm
CABINET FRONT
SCREW