Advertisement
Quick Links
LCD PROJECTOR LENS
MODEL NO. PLC-LNS07
LENS REPLACEMENT PROCEDURE
The focus and zoom of this lens can't be adjusted by controls on main cabinet or the remote control unit.
Lens replacement should be performed by the qualified service personnel.
It should be followed by this procedure precisely.
Before attempt to replace the lens, confirm the model number (both the LCD
projector and the lens) and use the proper lens.
If you have any questions, contact to the dealers.
Following checks and confirmations should be taken for safety.
Check the following things by the time of the cabinet cover installation after
the lens replacement.
1. Confirm the proper wiring and the wires are fixed properly.
2. Confirm the each connector is connected properly.
3. Wiring must not be tangled in the gear of the lens motor or the other
mechanical part.
4. There is no missing part, or no loosing mounting part.
PLC-LNS08
NOTES ON LENS REPLACEMENT
PARTS LIST
Following parts are contained in the packing.
· LENS
· LENS MOUNTING SCREWS
· DRIVER
· LIGHT-BLOCK SHEET
· LENS COVER
1 piece
6 screws (2 for spare)
1 piece
1 sheet
1 set
1AA6P1P1732-- (ICKV)
Advertisement
Related Manuals for Sanyo PLC-LNS07
Summary of Contents for Sanyo PLC-LNS07
-
Page 1: Lens Replacement Procedure
LCD PROJECTOR LENS MODEL NO. PLC-LNS07 PLC-LNS08 LENS REPLACEMENT PROCEDURE The focus and zoom of this lens can’t be adjusted by controls on main cabinet or the remote control unit. NOTES ON LENS REPLACEMENT Lens replacement should be performed by the qualified service personnel. - Page 2 1. Turn on the LCD projector. 2. Adjust the lens shift, so that lens is set in the center. 3. Turn off the LCD projector and disconnect the power cord from the AC outlet. 4. Remove 4 screws of the lens cover and remove the lens cover.
- Page 3 ATTACHED DRIVER INSTALL THE LIGHT-BLOCK SHEET. (See figure-4) Install the light-block sheet around the lens as shown in Figure. When this projector permanently install in the structure, slide the picture, obtain correct focus, then lock the lens by Focus Lens Lock screw at this step.