Error Lights - Wayne DW-10 Operation Manuals


Cutter lock:
If the auto cutter blade stops operating due to a jam, the ERROR light blinks. Clear the jam
and press the FEED button. If the blade does not move, refer to section 3.2.

Paper jam:
When paper is fed 3 inches, the receipt sensor detects it. After the paper is cut, it is
determined to be a jam when the paper doesn't reach the sensor position at that time.
The printer memorizes whether there is paper on the receipt sensor when the print begins.
Table 3-1 Power light and Error light for detected symptoms
Symptom Detected
Paper end
Paper near end
Front door open
Head up
Head up *1
Head overheat
Cutter lock
Paper jam
Memory check error*2
Low voltage error*2
High voltage error*2 *3
*1 Head up while the printer is printing.
*2 Requires power cycle to clear error.
*3 High voltage or excessive current. This error indicates electrical problem, head jammed or
head too cold. Most commonly seen at install/startup during very cold conditions.
_____________________________________________________________________________________
P/N 000-920921- Rev 0D 04/2015
POWER Light Status
ON
ON
ON
ON
ON
ON
ON
ON
Quick blinking
ON
ON
Indicates two short blinks and a long blink
ERROR Light Status
ON
ON
ON
ON
Blinking
Slow blinking
OFF
9