Storing Sw Frequencies In Memory - Radio Shack DX-398 Owner's Manual

3. Repeatedly press
the page where you want to store
the frequency.
1
under PAGE .
Notes:
• flashes only when the
PAGE
receiver is set to SW mode.
• If you wait more than 10 sec-
onds to press
stops flashing.
• If you pressed
1, does not appear be-
PAGE
cause there is only one LW
page.
4. Press . MEMO
M/MEM
about 12 seconds. The number for
the first available empty memory
location for the selected page
flashes next to MEMO
Note: If an empty memory loca-
tion number does not flash, all
memory locations are full in the
band you selected. If this hap-
pens, clear a memory location
(see "Deleting a Station You
Stored" on Page 30) then store
the frequency. Or, to replace a
stored frequency with a new fre-
quency, repeatedly press
28
to select
PAGE
or appears
2
, PAGE
PAGE
in Step
ATS/LW
flashes for
STORING SW
FREQUENCIES IN
MEMORY
.
Follow these steps to store shortwave
frequencies into empty memory loca-
tions in the shortwave page.
TUN-
or to select a new
ING
frequency, press
press the number key for the
memory location. After a few sec-
onds, the receiver beeps and
stores the new frequency in the
memory location.
5. Press to store the fre-
ENTER
quency in the flashing memory
location. The receiver beeps and
a bracket appears around the
memory location number where
you stored the frequency, to show
that the frequency was stored
there.
1. Press
METER/SW
shortwave band.
2. Tune to the frequency you want to
store. The currently selected page
number appears under
3. Press . PAGE
M/MEM
flash for about 10 seconds.
, then
M/MEM
to select the
.
PAGE
and MEMO