Kenwood TK-7108 Service Manual page 16

TK-7108
3. Attach a new cushion (G13-1960-08) to the DC bush.
!"#=EdNPJNVSMJMUF=
PK
Cushion / 缓冲垫
4. Place the KCT-39 sumi tube along the chassis and insert
the cable tie into the TX-RX PCB slot, as shown in the dia-
gram below.
!"#h`qJPV=pìãá=qìÄÉ
QK
!"#quJou=m`_
Insert the cable tie
into the slot here
把电缆线卡插入到此槽内
5. Align the KCT-39 cable to the left side of the DC cord, then
place the DC cord back into its slot along the chassis (over
the top of the KCT-39 sumi tube).
!"a`
RK h`qJPV
!=E h`qJPV=pìãá=qìÄÉ
In this direction / 在此方向
16
REALIGNMENT /
!
a`
!"#$%&'()
KCT-39 sumi tube
KCT-39 Sumi Tube套管
!" #$%&a` !"
!F
!
6. Twist the large grouping of wires of the KCT-39 cable
twice, then connect it to Terminal A of the PCB.
Connect the remaining grouping of wires of the KCT-39
cable to Terminal B.
!"#$ %&'()*+ ,-.#/01
SK h`qJPV
!"#$^
m`_
!h`qJPV !"#$%&'($)_
Terminal A
终端接线座A
7. Align the terminal B KCT-39 cable underneath the terminal
A cable align the speaker cable (T07-1082-05) below both
KCT-39 cables.
!"#$_= h`qJPV
TK
!" #$%&'(=EqMTJNMUOJMRF=
In this direction Speaker cable
在此方向 扬声器电缆
Terminal B
终端接线座B
!"#$%&'^
h`qJPV