Table of Contents
Advertisement
4
COMMISSIONING THE SYSTEM
This section provides the initialization and setup procedures for the Deko4078SD
signal booster. The procedures are performed through an Ethernet connection
between the Deko4078SD signal booster and a computer.
Note. This chapter only describes the parameters required to provision the Deko4078SD
signal booster. The application window options are fully described in Chapter- 5 .
4.1
O
PENING A
4.1.1
C
ONNECTING THE
To open connect the Signal Booster to the Computer
Connect the Ethernet cable (supplied) between the Main units' front panel Ethernet
port (see figure below) and the computer Ethernet port.
4.1.2
C
ONFIGURE THE
You will now configure the computer network parameters to communicate with the
Booster. Note that the procedure may vary slightly depending on the operating
system installed on your computer. The following procedure is for Windows XP.
To configure the computer's network parameters:
1. Click the Start menu and choose Control Panel.
2. In the Control Panel, click Network and Internet Connections.
3. Click Network Connections and then double-click Local Area Connection
The Local Area Connections Properties dialog appears with the General tab
displayed by default.
S
ESSION
S
B
IGNAL
OOSTER TO THE
Figure 10. Connection to Computer
C
N
OMPUTER
ETWORK
C
OMPUTER
P
ARAMETERS
Advertisement
Table of Contents
