Table of Contents
Advertisement
P
M
RODUCT
ANUAL
3
PHYSICAL INSTALLATION
This section describes the installation procedure for the Dekolink 700/800 DMSB
system.
3.1
O
VERVIEW
The system is supplied in a cabinet with the required connections.
For this type of system, the installation procedure consists of:
1. Selecting a location for the system according to the requirements described in
Chapter- 2 .
2. Unpacking the cabinet system (see 3.2)
3. Connecting the Donor and Service antennas (see 3.3)
4. Verifying that the ground is connected (see 3.4)
5. Connecting the wall power outlet to the power-supply (see 3.5)
Important: Be sure to perform the power supply connection last, otherwise damage
may be caused to the system!
6. Commission the system. See Chapter 4 .
It is important to perform the installation procedure according to the order described
above.
3.2
U
NPACKING
Upon receiving the Deko4078SD Signal Booster, perform the following:
1. Examine the shipping container for damage before unpacking the unit.
2. Perform a visual inspection to reveal any physical damage to the equipment.
3. Verify that all of the equipment (listed below) is included. Otherwise contact
Dekolink Wireless Ltd.
Deko4078SD is shipped with the equipment listed in the supplied parts list document.
Page 18
D
4078SD M
-C
EKO
ULTI
HANNEL
Proprietary Data
S
B
D
IGNAL
OOSTER
EKOLINK
P/N 300SC30031 Rev. 1.2
W
L
.
IRELESS
TD
Advertisement
Table of Contents
