Necessary Settings before Use
Charging the Battery Pack
1
Close the LCD monitor to turn off the
camera.
2
Attach the battery pack.
Slide the battery pack down until it locks
in place.
Bottom of the Camera
3
Connect the AC adapter.
DC Jack
AC Adapter
•
If the provided AC adapter is AP-V14E,
connect the power cord to the AC adapter,
and plug the power cord into an AC outlet.
•
You can also connect the AC adapter using
the Everio dock connector. (p. 9)
•
The power/charge lamp blinks to indicate
charging has started.
•
When the lamp goes out, charging is
finished. Unplug the AC adapter from the
AC outlet and disconnect the AC adapter
from the camera.
1
battery pack.
To AC Outlet
(110V to 240V)
7
To detach the battery pack
Slide and hold BATT. (step 2), then
remove the battery pack.
7
To check the remaining battery power
See page 15.
NOTES
•
You can also use the camera with just the
AC adapter.
•
Please do not pull or bend the AC adapter
plug and cable. This may damage the AC
adapter.
Date/Time Setting
1
Open the LCD monitor to turn on the
camera.
2
When [SET DATE/TIME!] appears,
select [YES] within 10 seconds.
If you do not select within 10 seconds, the
screen disappears. In such case, press
the POWER button and turn the camera
on again.
3
Set the date and time.
Repeat this step to input the day, month,
year, hour and minute.
4
Touch the OK button to finish.
7
To change the date and time
1) Touch the MENU button.
2) Select [BASIC SETTINGS], and then
[CLOCK ADJUST].
3) Set the date and time.
7
To return to the previous screen
@
Select
.
7
To quit the screen
Touch the MENU button.
SET DATE/TIME!
YES
NO
DATE
TIME
20
08
2008
12 13