Necessary Settings Before Use; Charging The Battery Pack - JVC GZ-HD7E/EK Instructions Manual

Necessary Settings before Use

Access/Charge
Lamp
Set Lever
Be sure to confi gure the following three
settings before use.

Charging the Battery Pack

1
Set the power/mode switch to OFF.
Slide while pressing down the lock button.
2
Attach the battery pack.
Slide the battery pack down until it locks
in place.
BATT.
16
Power/Mode
Switch
OFF
(CHARGE)
3
Connect the AC adapter.
AC Adapter
(ex. AP-V17E)*
* If the provided AC adapter is AP-V14E,
connect the power cord to the AC adapter,
and plug the power cord into an AC outlet.
•
The access/charge lamp blinks to indicate
charging has started.
•
When the lamp goes out, charging is
fi nished. Unplug the AC adapter (or
the power cord) from the AC outlet and
disconnect the AC adapter from the camera.
Required charging / recording time
(approx.)
Battery pack Charging time
BN-VF815U
2 hr. 40 min.
(Provided)
BN-VF823U 3 hr. 50 min.
* When using the viewfi nder.
8 To detach the battery pack
Slide and hold BATT. (
remove the battery pack.
8 To check the remaining battery power
See page 18.
NOTES
•
You can also use the camera with just the
AC adapter.
•
Please do not pull or bend the AC adapter
plug and cable. This may damage the AC
adapter.
DC Connector
To AC Outlet
(110V to 240V)
Recording
time
1 hr. 20 min.
(1hr. 25 min.*)
2 hr. 00 min.
(2 hr. 10 min.*)
step 2), then