Necessary Settings Before Use; Charging The Battery Pack - JVC GZ-MG333 Manual Book

Necessary Settings before Use

Be sure to confi gure the following three
settings before use.

Charging the Battery Pack

1
Close the LCD monitor to turn off the
camera.
2
Attach the battery pack.
Slide the battery pack down until it locks
in place.
Bottom of the Camera
3
Connect the AC adapter.
DC Jack
AC Adapter
•
If the provided AC adapter is AP-V14E,
connect the power cord to the AC adapter,
and plug the power cord into an AC outlet.
•
The charge lamp blinks to indicate charging
has started.
•
When the lamp goes out, charging is
fi nished. Unplug the AC adapter (or
the power cord) from the AC outlet and
disconnect the AC adapter from the
camera.
16
BATT.
To AC Outlet
(110V to 240V)
L
To detach the battery pack
Slide and hold BATT. (
remove the battery pack.
L
To check the remaining battery power
See page 18.
NOTES
•
You can also use the camera with just the
AC adapter.
•
Please do not pull or bend the AC adapter
plug and cable. This may damage the AC
adapter.
step 2), then