Cisco N9K-C93180YC-FX Configuration Manual page 14

Converting Ethernet Ports to Fibre Channel
Procedure
Step 1
Step 2
Step 3
Converting Ethernet Ports to Fibre Channel
This section explains how to convert Ethernet ports to fibre channel ports.
Before You Begin
This task requires installing and enabling the port license. For more information, see
Channel Port License, on page
Procedure
Step 1 Perform TCAM carving.
Example:
Step 2
Confirm that feature-set fcoe-npv is installed and enabled.
Example:
Switch(config)# install feature-set fcoe-npv
Switch(config)# feature-set fcoe-npv
Step 3 Convert the port(s) to FC.
Example:
After the conversion, save the configuration and reload the switch.
Note
Cisco Nexus 9000 Series NX-OS FC NPV Configuration Guide
14
Command or Action
switch# configure terminal
switch(config)# install feature-set fcoe-npv
switch(config-npv)# feature-set fcoe-npv
13.
Switch(config)# hardware access-list tcam region ing-racl 1536
Switch(config)# hardware access-list tcam region ing-redirect 256
Switch(config)# slot 1
Switch(config)# port 1-4,45-48 type fc
Port type is changed. ACTION REQUIRED: Please save configurations and reload the switch
Ports can be converted only in groups (sequential or random) of 5 (multiples of
4).
Configuring N Port Virtualization
Purpose
Enters configuration mode.
Installs the FC and FCoE NPV feature set.
Enables FC and FCoE NPV.
Installing the Fibre