JVC KD-R516 Instructions Manual page 15

Category Menu item
L/O MODE
Line output
mode
SUB.W FREQ *
Subwoofer cutoff
frequency
SUB.W LEVEL *
Subwoofer level
BEEP
Keytouch tone
AMP GAIN *
Amplifier gain
control
7
AM *
AM station
8
AUX IN *
Auxiliary input
5
* Displayed only when <L/O MODE> is set to <SUB.W>.
6
* The volume level automatically changes to "VOLUME 30" if you change to <LOW POWER> with the
volume level set higher than "VOLUME 30."
7
* Displayed only when any source other than "AM" is selected.
8
* Displayed only when any source other than "AUX IN" is selected.
Selectable setting, [
• SUB.W
• REAR
5
• LOW
• MID
• HIGH
5
SUB.W 00 —
SUB.W 08
[SUB.W 04]
• BEEP ON
• BEEP OFF
6
• LOW POWER
• HIGH POWER
• AM ON
• AM OFF
• AUX ON
• AUX OFF
Initial: Underlined
: Select if the REAR LINE OUT terminals are
used for connecting a subwoofer (through
an external amplifier).
: Select if the REAR LINE OUT terminals are
used for connecting the speakers (through
an external amplifier).
: Frequencies lower than 72 Hz are sent to the
subwoofer.
: Frequencies lower than 111 Hz are sent to
the subwoofer.
: Frequencies lower than 157 Hz are sent to
the subwoofer.
: Adjust the subwoofer output level.
: Activates the keypress tone.
: Deactivates the keypress tone.
: VOLUME 00 – VOLUME 30 (Select if the
maximum power of each speaker is less than
50 W to prevent damaging the speakers.)
: VOLUME 00 – VOLUME 50
: Enable "AM" in source selection.
: Disable "AM" in source selection.
: Enable "AUX IN" in source selection.
: Disable "AUX IN" in source selection.
]
ENGLISH 15