Accu-Chek Inform II Operator's Manual page 2
Hide thumbs
Also See for Inform II:
- Operator's manual (199 pages) ,
- Quick reference manual (39 pages) ,
- Manual (39 pages)
Table of Contents
Advertisement
Revision History
Manual versions 1, 2, 3 and 3.1 are for Accu-Chek Inform II meters with serial number versions
UU13000000 to less than UU14000000. Manual versions 4, 5 and 6 are for Accu-Chek Inform II
meters with serial number versions greater than or equal to UU14000000.
Manual version
Version 1.0
Version 2.0
Version 3.0
Version 3.1
Version 4.0
Version 5.0
Version 6.0
Revision date
2012-10
2013-02
2013-03
2017-04
2014-02
2015-03
2017-04
08424705001 (01) 2017-04 USA • Accu-Chek Inform II Operator's Manual Version 6
Changes
New document
Upgrade to FW 03.04; Revise critically ill statement
Update cleaning and disinfecting chapter
Add "Rx only" to Version 3.0 Operator's Manual.
Transition to new meter hardware; 2D barcode
scanner, modifications to wireless LAN option
(separate insertable RF card replaced by integrated
WLAN component); new battery pack. Update to
SW 04.00; misc. editorial revisions.
Correct two typographical errors in chapter 1,
Introduction, Overview of the Accu-Chek Inform II
Base Unit Hub section.
SW 04.01 and low power icons implemented; update
to SW 04.02; new Base Unit in "System overview"; new
section "What is new..."; new Appendix E for legacy
Base Unit; misc. editorial revisions.
Advertisement
Table of Contents
Need help?
Do you have a question about the Inform II and is the answer not in the manual?
Questions and answers
my code key reader does not work , how can i manually enter a new strip lot
To manually enter a new strip lot on an Accu-Chek Inform II code key reader, follow these steps:
1. Open the Main Menu screen.
2. Select "Strip Lots" to access the related menu.
3. Touch "Add" to enter a new test strip lot from a new code key.
4. Insert the new code key into the code key reader.
5. The LED on the reader will flash green, indicating it is ready to transfer data.
6. The reader remains ready to send data for a few seconds after transmission, allowing multiple meters to receive the data without reinserting the code key.
This completes the manual entry of a new strip lot using the code key reader.
This answer is automatically generated